[MVMA] AREDN device firmware update: 2 and 5 GHz XW devices: good news + POE test

[William Curtice]

Interesting.

Suggest you also measure stable steady -state temperature of PoE with no
load attached.

Bill

William Curtice
937-287-0871
Please reply to: william.curtice at ieee.org

On Fri, Nov 23, 2018, 7:52 AM Chuck Gelm <nc8q-mesh at gelm.net wrote:

> For the record:
>
>  I powered 3 nodes from (1) one 24V *0.5A 12W* Ubiquiti POE.
> I set a thermometer on the POE.
>   After a few hours the display indicated *79 degrees* F.
>
>  Next, I powered the same 3 nodes from (1) one 24V *1.0A 24W* Ubiquiti
> POE.
> I set a thermometer on the POE.
>   After a few hours the display indicated *79 degrees* F.
>
> Two (2) of the nodes were set to minimum TX power.
> I may repeat this test with all nodes as maximum TX power.
>
> Chuck
>
>
> _______________________________________________
> MVMA mailing list
> Home: http://mailman.qth.net/mailman/listinfo/mvma
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:MVMA at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mailman.qth.net/pipermail/mvma/attachments/20181123/48f8be8f/attachment.html>