[MRCA] GRC-109

[Tim]

Good deal Rich - One thing I would test early is the receiver filament
voltage.  There are wire wound tapped resistors in the power supplies to
adjust the 1.35 +/- 0.10 volts source; verify it is set properly under
load. (receiver on...).  see manual.  Those 1L6's are expensive!

Have fun with it!
Tim
N6CC

On Fri, Jul 24, 2020 at 7:17 PM Rich Arland <k7sz at live.com> wrote:

> I found a 1L6, NIB NOS with JAN numbers on it for $30 on ebay. Thanks to
> Zorro who advised me to check on solid state replacements for the 1L6. I
> found a SS replacement but it was just about as expensive as a new one.
> Also picked up some SS replacements for 6X4 rectifier tubes. I need to get
> my 109 set out of the case and on the air.
>
> *Vy 73*
>
> *Rich  K7SZ*
>
>
>
> ______________________________________________________________
> MRCA mailing list
> Home: http://mailman.qth.net/mailman/listinfo/mrca
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:MRCA at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mailman.qth.net/pipermail/mrca/attachments/20200724/7a0a15b1/attachment.html>