[MRCA] T-195A test

[mac]

On Jun 6, 2013, at 12:16 PM, Robert Newberry wrote:

> I'm getting ready to test my 195A. My plan was to use dummy load and  
> follow the tune up directions in the manual. I do not have the cable  
> yet to connect R-392.
>

No problem operating without the receiver

> Is there any reason or potential harm in just firing up and putting  
> out a test signal into my dummy load with out the R-392 connected?
>
> I'd like to be able to operate it out of the enclosure to watch for  
> magic smoke, but I understand a safety interlock must be defeated.
>

Just pull the safety interlock pin on the back of the chassis OUT to  
put it in the override position.  You will have to wiggle it around a  
bit to do this
> Anyone have any suggestions on things that should be lubed, cleaned,  
> or checked before fire up?
>

Just make SURE you have a dummy or other load connected before you  
turn it on.  This radio will try to load up into nothing and will  
develop destructive internal voltages in the process.

Dennis D.  W7QHO
Glendale, CA

**************
> Apparare Scientior
> Paratus Communicare
> -N1XBM
>
> ______________________________________________________________
> MRCA mailing list
> Home: http://mailman.qth.net/mailman/listinfo/mrca
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:MRCA at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html