[MRCA] need pwr connector pin connections to power CFD-60006A SigGen (no...

[Poli, Lou-p4924c]

Robert;
 Thank you. 
Does the power supply drive the test equipment directly or the larger composite radio set LP-5? 
The only equipment I have is the Sig Gen.

In my shop I have AC and DC sources. I need the input description of the sig gen power connector to complete the project.

I saw your web page. Nicely done and informative.
Best regards,
 Louis

-----Original Message-----
From: mrca-bounces at mailman.qth.net
[mailto:mrca-bounces at mailman.qth.net]On Behalf Of WA5CAB at cs.com
Sent: Saturday, August 19, 2006 12:24 PM
To: mrca at mailman.qth.net
Subject: Re: [MRCA] need pwr connector pin connections to power
CFD-60006A SigGen (no...


Louis,

I unfortunately don't have the manual for either unit but the LP-5 had a 
separate AC operated power supply, CFD-20080-A.  Somewhere around here already 
boxed for shipping I have one in excellent cosmetic and physical condition.  S/N 
1074.  $55.00 plus shipping OBO.

In a message dated 8/19/2006 2:07:40 PM Central Daylight Time, 
Lou.Poli at gdc4s.com writes: 
> I have a pristine  CFD-60006A RF Standard Signal Generator. The name plate 
> notes that it is test equipment of the LP-5 radio equipment. 
> Frequency range is 9.5 KHz to 50 MHz.
> 
> I was successful in obtaining the schematic off the web, but the only one I 
> could find was the 120 VAC powered version. Mine is the DC driven version, 
> with the standard receptacle for the voltages on the front panel. 
> 
> I do not want to risk powering it up improperly.
> 
> Does anyone have the DC power supplied version of the Sig Gen schematic (or 
> connector pin layout) for this Sig Gen, or know a web site or seller for the 
> manual.
> 

Robert Downs - Houston
<http://www.wa5cab.com> (Web Store)
MVPA 9480
<wa5cab at cs.com> (Primary email)
<wa5cab at houston.rr.com> (Backup email)
_______________________________________________
MRCA mailing list
MRCA at mailman.qth.net
http://mailman.qth.net/mailman/listinfo/mrca