[Motorola] Comm port setting for Ribless Prog. Cable?

[tvsjr at tvsjr.com]

If the mouse driver runs at boot time and you're unplugging the mouse later and plugging in the RIB, the driver will capture the com port and it won't work. Disconnect the serial mouse and plug the cable in. When the computer boots and says starting ms-dos, hit F5. This will prevent any drivers from loading. Load the software and try it again.

------Original Message------
From: w7trh at comcast.net
Sender: motorola-bounces at mailman.qth.net
To: Motorola at mailman.qth.net
ReplyTo: Discussion of equipment manufactured by Motorola
Subject: [Motorola] Comm port setting for Ribless Prog. Cable?
Sent: Dec 17, 2009 12:57



Hello Gang, 



Should the Com1 setting be the same as the serial mouse uses, when I plug in the ribless prog. cable? (HT1000). I am not getting any indication of cable being connected. 

Computer is 486DX-33, running Win 3.11 and Dos 6.20 (Am running at 16 mHz speed) 



RSS is ver. 3.00.00..................No indication of radio connected. I do not want to condemn the cable yet. 



Any ideas or comments will be well taken.......................Merry Christmas Season! 



Tim W7TRH / AFA0TP 

Vashon Is. Wa. 
______________________________________________________________
Motorola mailing list
Home: http://mailman.qth.net/mailman/listinfo/motorola
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Motorola at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html

Sent via BlackBerry by AT&T