[Motorola] Radius

[Brandon]

----- Original Message -----
From: "Ken Cechura" <kcechura@umr.edu>
To: <motorola@mailman.qth.net>
Sent: Monday, August 12, 2002 4:17 PM
Subject: [Motorola] Radius


> Whats the impedance of the Radius Speaker?  (I think it's the radius
mobile
> that has a speaker on the front panel??)
> thanks
> Ken

According to the magnet on my mobile it is a PSI Part No 5000065064 and is 4
ohms at 5 watts
This is the speaker that mounts inside the HCN3293B 2-mode Maxtrac front
housing however the Radius branded products may also use this. Any speaker
at 4 to 16 ohms will work however if you are wanting to impedance match this
output remove the square 2 ohm resistor at the back of the board and match
for 4 ohms. The resistor was intended to reduce the power to the speaker and
help balance things out should one want to drive an external speaker without
killing the internal.

Hope this helps ya out

73

Brad KA�SQO