[Milsurplus] NOS ARR-15 / ARC-2 connectors

[AKLDGUY]

I don't know whether this is appropriate to the radios discussed here, but
I am using 1/8 x .014 brass tube to connect to two pins of my BC-442-A
antenna relay. Made by K & S Precision Metals of Illinois. Catalog # 8127,
length 12 inches. Nice firm fit, no crimping required. If it can sell in a
hobby shop for $3.50 here in Auckland, you can bet it's less in the US.

www.ksmetals.com

Neil ZL1ANM


On Tuesday, June 19, 2018, Jim Whartenby <antqradio at sbcglobal.net> wrote:

> To answer Robert's question in his 3rd paragraph below.
>
> I did some measurements on the ARR-15 male connector pins and the mating
> socket contacts.  Also did the same for the K connector #10 contacts.
> Obviously there must be a deeper socket depth then the pin length to
> prevent deforming the socket and keep proper contact tension to allow the
> socket to grip the pin.  Keep it clean guys!
>
>
>
>
>
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mailman.qth.net/pipermail/milsurplus/attachments/20180619/f9a9788b/attachment.html>