[Milsurplus] tcs dual dynamotor lubing

[John Kidd]

Hi,

I've had success putting the tip of a very hot soldering iron on the
set screw. Use something like a Weller soldering gun
that gets very hot.

Good luck,

John Kidd

	folks

	i am trying to lube the bearings of the transmitter dynamotor. the
one end went fine. however i am trying to remove the fan at the other
end.  2 allen set screws tighten against the shaft i was able to
loosen one however the second one i could not loosen so it looks like
i will need to drill it out. do i need a little gear puller to remove
the fan?  once that gets pulled off inassume i can remove the 2
screws that hold the cover plate exposing the bearing?

	any advice would be appreciated

	thanks jeff kg2bz
-------------------------
Email sent using Optus Webmail
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mailman.qth.net/pipermail/milsurplus/attachments/20180116/8707c0e9/attachment.html>