[Milsurplus] Receiver wanted (for GO-9)

[WA5CAB at cs.com]

In the CW-62017 24/28 V Junction Box, resistors 180 and 181 (each 10.8 
ohms/35 watts wire wound) are each individually in series between the +LV line 
fuse and the ON-OFF switch in each receiver control box.  The other side of 
the switch goes to one of the two dynamotor start relay coils and to one of 
the two receiver filament strings, which are each three parallel strings each 
of two tube filaments in series.

Robert Downs - Houston
wa5cab dot com (Web Store)
MVPA 9480

In a message dated 07/17/2017 15:21:52 PM Central Daylight Time, 
COURYHOUSE at aol.com writes: 
> ok  what  part controls the  filament  voltage then?
>   
>  In a message dated 7/17/2017 1:16:40 P.M. US Mountain Standard Time, 
> milsurplus at mailman.qth.net writes:
>  
> >> Yes.  But they both use the same receiver (CW-46048D).  The only 
>> difference between a receiver marked for RU-18 and one marked for RU-19 is the 
>> nameplate.  The electrical differences are the dynamotor and the junction 
>> box.  
>> 
>> In a message dated 07/17/2017 14:48:07 PM Central Daylight Time, 
>> milsurplus at mailman.qth.net writes: 
>> >>> Is the RU 18 the same as the RU-19 except   18 is  12-14 volts   and 
>>> the 19 is  24v..... 
>>> 
>>> Ed@   www.smecc.org 
>>> 
>>> 
>> 
> 
> 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mailman.qth.net/pipermail/milsurplus/attachments/20170717/5a8ca93c/attachment.html>