[Milsurplus] Mounting hole spaceing for the BC-348

[John Hutchins]

John -
Do you have 2 or 2 #8/32 screws ~1" long?
Thread them in the chassis ~1/4 -to-1/2 " down,  measure edge to edge.  
Now there is a key pin to take care of also off set from center;
   Now I'm not say-N this is accurate for your  BC-348, please disregard 
D holes, The B holes are for the R bottom cover standoffs, may not apply 
in your case:, The A hole, },  is the Key Pin location for B type receivers.
https://drive.google.com/file/d/0BwI41VtFGMtCMmU4VjJjZVl0OWs/view?usp=sharing
It may be a bit on the light side  should help.

Hutch

On 1/30/2016 7:37 PM, John Watkins via Milsurplus wrote:
> Hi All,
>
> I am building a new supply for my BC-348Q, and wonder if anyone has 
> the spacing for the mounting holes from the Dynamotor plate? I 
> currently have a kludged together supply mounted, but everything is 
> soldered in and would be a PIA to remove at this stage.  I have cut a 
> plate of 1/8"  Aluminum and want to drill the holes for mounting it 
> back onto the old Dynamotor mounting surface.  Anyone have this data, 
> looked all over, but couldn't find it.
>
> TIA
>
> John WD5ENU
>
>
> ______________________________________________________________
> Milsurplus mailing list
> Home: http://mailman.qth.net/mailman/listinfo/milsurplus
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Milsurplus at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mailman.qth.net/pipermail/milsurplus/attachments/20160130/a4cb7833/attachment-0001.html>