[Milsurplus] Worm Drive

[J. Forster]

BTW, you don't really NEED a Metric worm and wheel!

You need a mathing worm & wheel, WITH METRIC BORES. The tooth form, pitch,
etc don't matter as long as they math.

The other thing that matters is the spacing between the shafts, so the
gears mesh properly.

-John

=================






> Try these folks. They've been around for >50 years and make wonderful
> stuff.
>
> http://www.pic-design.com/worm-gears.html
>
> If they have something close, they used to do mods for very reasonable
> prices.
>
> -John
>
> =============
>
>
>
>> I'm looking for a custom made miniature worm drive manufacturer to
>> replace
>> a faulty nylon one. The worm motor has a 2mm shaft & the output gear is
>> on
>> a 3mm shaft. The ratio is 10:1. Anyone know who can make this? , I have
>> photos and dimensions.
>>                                                                         
>>  
>>                                                                        
>>  
>>                         Thanks, Brad       
>> ______________________________________________________________
>> Milsurplus mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/milsurplus
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Milsurplus at mailman.qth.net
>>
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
>>
>>
>
>
> ______________________________________________________________
> Milsurplus mailing list
> Home: http://mailman.qth.net/mailman/listinfo/milsurplus
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Milsurplus at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>
>