[Milsurplus] Attaching cable to MS connectors

[J. Forster]

Hi,

I got the dyno in and it runs very well, putting out about 259 VDC at 24
VDC in. It draws about 60 mA, no load, and is very quiet. I've not fit
checked it in the ARB as yet.

Thanks very much.

-John

===========



> I'm about 95% sure that it is for the ARB.  The mounting arrangement (four
> captive screws on outriggers) and the terminal board matches the outline
> drawing and the rather unusual 260VDC output voltage rating matches a
> chart in
> the manual.  The only photograph in the manual that shows the dynamotor
> isn't much help but what is visible looks like the unit on eBay aside from
> contractor.  But the manual does say that the dynamotors were made by
> several
> different ones.
>
> In a message dated 10/23/2012 18:42:06 PM Central Daylight Time,
> jfor at quikus.com writes:
>> Hi Mike,
>>
>> Yes. Might be. I don't have the doc to check. Maybe Robert can answer
>> back
>> in time.
>>
>> Thanks very much,
>>
>> -John
>>
>> ===================
>>
>>
>> >OJohn,
>> >
>> >Was it you who was looking for an ARB dynamotor?  I think this might be
>> >one, though I didn't check the number.  Gotta be quick, though.
>> >
>> >
>> http://www.ebay.com/itm/WESTINGHOUSE-DYNAMOTOR-957962-A-/320999817765?pt=US_Radio_Comm_Device_Power_Supplies&hash=item4abd148225
>> >
>> >
>>
>
> Robert Downs - Houston
> wa5cab dot com (Web Store)
> MVPA 9480