[Milsurplus] Attaching cable to MS connectors

[Dave Maples]

All: For use in the shack, I have found that leaving off the 7-turn locking
ring  on the MIL-C-5015 series connectors is usually adequate practice.
Connector pin friction is usually plenty to hold the connector in place.
It's different if it's the quarter-turn connectors.

Thanks,
Dave WB4FUR

-----Original Message-----
From: milsurplus-bounces at mailman.qth.net
[mailto:milsurplus-bounces at mailman.qth.net]On Behalf Of Bill Cromwell
Sent: Wednesday, October 17, 2012 8:18 PM
To: milsurplus at mailman.qth.net
Subject: Re: [Milsurplus] Attaching cable to MS connectors


Hey...

Make sure any collars, rings, threaded parts are not slipped on wrong
side to! I did THAT *once*.

73,

Bill  KU8H


On Wed, 2012-10-17 at 23:01 -0400, COURYHOUSE at aol.com wrote:
> never forget the   threaded collar....    did that  once....  ONLY ONCE!
>
> Ed#
>
>


______________________________________________________________
Milsurplus mailing list
Home: http://mailman.qth.net/mailman/listinfo/milsurplus
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Milsurplus at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html