[Milsurplus] Socket question need a suggestion.

[B Smith]

I have found in the past that using any sort of 
connector for 3 pin regulators is  unreliable.
I usually just fabricate a small circuit board for 
the  connections and mount the board on the 
chassis.
See:

(http://k4che.com/Regulator%20Pad%20mount/reg%20pad%20mount.htm)

73

breck k4che


--------------------------------------------------
From: "John Hutchins" 
<olegerityincj at austin.rr.com>
Sent: Tuesday, November 23, 2010 9:12 PM
To: <Milsurplus at mailman.qth.net>
Subject: [Milsurplus] Socket question  need a 
suggestion.

> All -
>
> Ideas, sources and thoughts are being sought. 
> Yes this is for a BC-348
> Power supply.
>
> This will mount into an 0.063" thick aluminum 
> panel.
> Have a 3 pin mosfet for a regulator circuit 
> based on IRF730PBF simple
> regulator circuit.
> Pins are >= 0.0402" or 1.02mm in Diameter and 
> .100" or 2.54 mm  center
> to center spacing.
> Looking for a 3 pin chassis mount female 
> connector with solder
> terminals.  Any ideas?
>
> I think  I could make one using surplus mil 
> connector pins, JB weld'ed
> on to FR-4 or PB panel, if an
> existing connector cannot be found.    Now I was 
> able to get all the
> parts at a cost <  15 Henry choke,
> and quite a bit lighter.
>
>
> Thanks
> Hutch
>
> ______________________________________________________________
> Milsurplus mailing list
> Home: 
> http://mailman.qth.net/mailman/listinfo/milsurplus
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Milsurplus at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: 
> http://www.qsl.net/donate.html
>