[Milsurplus] Socket question need a suggestion.

[John Hutchins]

All -

Ideas, sources and thoughts are being sought.   Yes this is for a BC-348 
Power supply.

This will mount into an 0.063" thick aluminum panel.
Have a 3 pin mosfet for a regulator circuit based on IRF730PBF simple 
regulator circuit.
Pins are >= 0.0402" or 1.02mm in Diameter and   .100" or 2.54 mm  center 
to center spacing.
Looking for a 3 pin chassis mount female connector with solder 
terminals.  Any ideas?

I think  I could make one using surplus mil connector pins, JB weld'ed 
on to FR-4 or PB panel, if an
existing connector cannot be found.    Now I was able to get all the 
parts at a cost <  15 Henry choke,
and quite a bit lighter.


Thanks
Hutch