[Milsurplus] BC-611 to external antenna

[Richard Arland, W3OSS]

Al:

Tell me you used your K&E Log-Log Deci-Trig sliderule for those 
calculations!!!

Vy 73,

Rich Arland, W3OSS

"Contrary to popular belief I do not have ADHD.....Oh, Look!! There's a 
chicken!!"


----- Original Message ----- 
From: "Al Klase" <al at ar88.net>
Subject: Re: [Milsurplus] BC-611 to external antenna


| Gene,
|
| I think you'll find 103.5 volts X 0.035 amps = 3.6225 watts.  That would
| be an efficiency of about 7%.  Hey, what's a couple of decimal places
| among friends? :-)
|
| Al
|
| ersmar at comcast.net wrote:
| > ......BTW - Does anyone out there in cyberland know what the sensitivity 
spec is for the BC-611?  Also, TM11-4019 - repair instructions for the 
BC-611 series - says that the TX output is 255 mW modulated (p 36, table XI) 
but the B+ batt drain is listed as 35 mA at 103.5 V for appr 36 mW nominal 
TX power comsumption.  Which is right, if either?  I'm preparing a slide 
presentation for the local radio club on squad radios and I'd like to 
compare pounds-per-Watt output for these milrads with modern HTs.  Thanks.
| >
| >
| -- 
| Al Klase - N3FRQ
| Flemington, NJ
| http://www.skywaves.ar88.net/
|
|
| ______________________________________________________________
| Milsurplus mailing list
| Home: http://mailman.qth.net/mailman/listinfo/milsurplus
| Help: http://mailman.qth.net/mmfaq.htm
| Post: mailto:Milsurplus at mailman.qth.net
|
|
| -- 
| No virus found in this incoming message.
| Checked by AVG Free Edition.
| Version: 7.1.412 / Virus Database: 268.18.0/689 - Release Date: 2/15/2007
|
|