[Milsurplus] #4-36 machine screws

[Mike Hanz]

Richard Brunner wrote:

> I wonder where I can find some #4-36 machine screws to dress-up my RALs?
> They're the tiny things holding the plates on the panel.  #4-40 is 
> common, but not #4-36.  The screws all came out hard, so I ran a tap 
> through the holes and the screws go in easily now.  Do holes shrink? 
> #4-40 screws will start, but won't go in more than a turn or two.  
> Some of the original screws look pretty bad, and I need more. 


An NS (national special) screw thread - not very common at all.  Try 
http://www.electronicplus.com/content/ProductPage.asp?maincat=ha&subcat=hme

73,
Mike