[Milsurplus] BC-348 Dial set removal

[W7QHO at aol.com]

In a message dated 12/26/06 6:09:20 PM, jwatkins at omantel.net.om writes:


> How does one get the small bolt out that holds the dial assembly to the 
> main chassis on the BC-348?  I have one out, but the other is a bear, behind and 
> under the worm gear and shaft for the vernier.   I had considered pulling 
> the Osc. assembly, but that also has a shaft running through it.  Any 
> suggestions?
> 

John,

Swapped out the dial mechanism on my 348K a number of years ago.   Didn't 
remember any particular problems so puled the chassis out of it's case to take 
another look and I see what you mean.   Believe I was able to get a 1/4" drive, 
12 point socket on the bolt head and turn it a few degrees at a time with a 
swivel-head drive handle.

Good luck.

Dennis D. W7QHO
Glendale, CA
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://mailman.qth.net/pipermail/milsurplus/attachments/20061226/ff829d73/attachment.htm