[Milsurplus] 35X032 Dynamotor

[WA5CAB at cs.com]

Database says Navy Type CMX-2880? (I seem to have left off the fifth digit 
when I entered it).  Also used on the 14 volt RL-5, 6 & 7 aircraft interphone 
amps which like the CMX-50128 (TCS) interphone amp were built by Magnavox.  I 
think 35X032 is the Magnavox part number but it could be Pioneer's.  Will fit 
the Command sets, as Jack said, and therefore is functionally interchangable 
with the CBY-21400 (RAT) and the DY-1/ARR-2X.

In a message dated 7/2/2004 2:39:23 PM Central Daylight Time, 
scr287 at sbcglobal.net writes: 
> These were the dynamotors for the intercom amplifier
> for the TCS. Just happened to fit the "ARC-5" family of
> receivers just fine. Swapping the tubes with 6 volt equivalents
> and using this dynamotor resulted in a no wiring changes
> 12 volt receiver.
> 
> Jack
> 
> Jack Antonio WA7DIA
> scr287 at sbcglobal.net
> 
> 
> ----- Original Message ----- 
> From: "David Stinson" <arc5 at ix.netcom.com>
> To: "aGEnuine Ham" <gl4d21a at juno.com>
> Cc: <milsurplus at mailman.qth.net>
> Sent: Friday, July 02, 2004 10:22 AM
> Subject: Re: [Milsurplus] 35X032 Dynamotor
> 
> 
> >No other markings?  Nameplate doesn't give any other information?
> >No nomenclature plate on the base?
> >
> >aGEnuine Ham wrote:
> >>Buried down in the bottom of a box of somethng else (car parts), I
> >>discovered a "Radio Dynamotor" 35X032 made for Magnavox by Webster
> >>products.  It has the base with 4 slide latches and 3 pin female 'jack'
> >>on the bottom and is the size of ARC-5 stuff (274N, it has a Navy
> >>inspection stamp), and W221597 stamped just below the anchor in what
> >>looks like the same ink.  Nmaeplate sez 14 V at 2.4 A in, 250 V at 60 ma
> >>out.

Robert Downs - Houston
<http://www.wa5cab.com> (Web Store)
<wa5cab at cs.com> (Primary email)
<wa5cab at houston.rr.com> (Backup email)