[Lowfer] VO1NA OP32

[Garry]

Jay, I like the Op32Rx v1.8.7 software.  Perhaps a newer version exists 
but I haven't looked. I do sometimes run Opera v1.6.5 but dislike it for 
the reasons you mentioned. Also, it falses more often and there's no way 
for you to remove bogus call signs from the deep search list. Nor is 
there a way to specify an arbitrary operating frequency, hence my lowfer 
shows up as if it's sending on about 137.5 kHz rather than 185.185 kHz.

  After I saw your note I had to relearn how to run  Spectrum Lab with 
opds2h6.exe. Finally got it going, but too late for VO1NA decodes. The 
very precise FFT takes a LONG time to acquire and I had things set up 
with a number of things that needed changed for 137.477 kHz. By about 
the third try I think I had caught all of them. Then I needed to start 
all over for SIW on 185.185 kHz, hi.

73, Garry, K3SIW