[Lowfer] WM and TAG overnight

[Michael Sapp]

OK Mike, I'll see what happens this evening, perhaps the K=0 and low A 
indexes will stay around and allow for effiicent propagation again....

73 Mike tts

----- Original Message ----- 
From: "N8OOU" <n8oou at meekfarm.us>
To: "Discussion of the Lowfer (US, European, & UK) and MedFer bands" 
<lowfer at mailman.qth.net>
Sent: Saturday, February 11, 2017 1:00 PM
Subject: Re: [Lowfer] WM and TAG overnight


> Mike - tts;
>
> Thanks for the capture. I performed a re-tune of the Pie design loading 
> coils yesterday using a new sweep/analyzer tool I have been constructing. 
> I left the coil spacing at the best reading from the tool. I am happy to 
> see that setting was in a spot to put out enough signal to reach PA. It 
> gives a little more credence to the meter.
>
> The graphics portion of the ID is transmitted with less "energy 
> concentration" so with a weak signal it will disappear before the QRSS. I 
> do detect a portion of the M in your capture.
>
> Thanks for listening.
>
> 73   de   N8OOU - Mike Meek
>
> On 02/11/2017 09:40 AM, Michael Sapp wrote:
>> HI All:  One copy of WM and TAG overnight before my PC decided to do a 
>> late night re-start....
>>
>>
>> https://www.dropbox.com/s/zw0gjssjdk9ovaa/WMTAG43.jpg?dl=0
>>
>>
>> I was unable to copy the "WM" character set but the dot and dash 
>> information was above the noise...
>>
>> 73 Mike wa3tts