[Lowfer] WM Lowfer

[N8OOU]

Garry,

Thanks for the WM capture. I have switched the LowFer exciter from the 
U3S to the Arduino Shield from QRPLabs, to be able to run my own custom 
graphic code. I plan to implement a code solution to be able to combine 
both the Hi- and Lo- Fer beacons into the one exciter and antenna 
system. For now the HiFer is still on a separate U3S/antenna.

It appears the frequency is .1 or .2 lower than I was wanting, so I will 
bring it up a touch.

In seeing your capture I can refine the graphics to better fit the QRSS 
30 speed. My local captures look fine, even with the RF signal 
attenuated. I realize now that as I reduce the RF signal, I am also 
reducing the associated noise.  I need to improve my test setup to 
better simulate the DX reception.

Again, thanks for listening.

73   de   N8OOU - Mike Meek

On 09/22/2016 08:49 AM, Garry wrote:
> Mike, I see WM coming through fine on the intended frequency. Only
> problem is the "dip" in both W and M is so quick at QRSS30 rate the
> letters would be hard to identify at low SNR.
>
> 73, Garry, K3SIW, EN52ta, Elgin, IL
>
>
>
> ______________________________________________________________
> Lowfer mailing list
> Home: http://mailman.qth.net/mailman/listinfo/lowfer
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Lowfer at mailman.qth.net
> Post must be less than 50KB total for message plus attachment!
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>