[Lowfer] WSPR 15 tonite on 73.0 Dial Freq 74.550 Tx Freq.

[Bob Raide]

JD;
I don't think the RX setup your using tonite is doing too bad!  You sent me a great capture few nites ago and that is daytime and over 1000 miles away with Summer conditions!  
Noise is always going to be the big problem on this long wave.  I am hoping the noise subsides as colder WX moves in for us.  Hate the dam cold but it sure is good for LF work!
Bob
 
> From: listread at lwca.org
> To: lowfer at mailman.qth.net
> Date: Fri, 27 Sep 2013 21:14:34 -0500
> Subject: Re: [Lowfer] WSPR 15 tonite on 73.0 Dial Freq 74.550 Tx Freq.
> 
> >>> have the radio tuned to 72.930 and listening at 1620 hz audio.
> 
> Not familiar with WSPR-X yet, but I concluded that's what I needed to do as 
> well if the transmit audio was set for 1550, outside the WSPR-15 spec.  Or 
> else, lie to it about my BFO frequency, but that gets even more confusing, 
> as I found out playing with WSPR-2 recently.
> 
> Unfortunately, it's a moot point here tonight.  Two BIG lines of storms in 
> the western part of the state already had it awfully noisy here before 
> sunset.  Couldn't even see MP, which is pretty drastic.  Hope for a chance 
> to try again in a couple of days when this moves past.  A good loop antenna, 
> probably with a sense antenna and a phaser for a bit of pattern flexibility, 
> is high on my list of priorities.
> 
> John D 
> 
> ______________________________________________________________
> Lowfer mailing list
> Home: http://mailman.qth.net/mailman/listinfo/lowfer
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Lowfer at mailman.qth.net
> Post must be less than 50KB total for message plus attachment!
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html