[Lowfer] Frequency check M P 137780.5

[jrusgrove at comcast.net]

Mitch

Right on 137780 ... +/- a couple mHz. Will be retasking SpecLab shortly. Can set back up tomorrow if 
you need it.

Jay W1Vd  WD2XNS  WE2XGR/2 WG2XRS/2


----- Original Message ----- 
From: "Mitch Powell" <mitch.powell at sympatico.ca>
To: <k3siw at sbcglobal.net>; "Discussion of the Lowfer (US, European, &amp;UK) and MedFer bands" 
<lowfer at mailman.qth.net>
Sent: Friday, September 27, 2013 5:27 PM
Subject: Re: [Lowfer] Frequency check M P 137780.5


> G'day Lloyd and Garry:
> Thanks - that was the sort of thing I needed....and both are very close to the same
> readout so what I did is re-calibrate my ARGO to the frequency you both were reading -
> and then use that readout to QSY up a bit. I am showing just a tiny bit above 50 now -
> so will let it settle and hope it doesn't change again.
>
> Thanks
>
> Mitch
> On 2013-09-27, at 5:12 PM, Garry Hess wrote:
>
>> Hi Mitch,
>>
>> As you can see from Jay's grabber, your frequency is a bit low if .5 is the target. It's very 
>> strong here and I have the ARGO gain at normal (meaning "high"). I notice signal artifacts above 
>> and below the main signal with two separate e-probe/SDR-IQ receivers and also when I use a loop. 
>> I've seen such artifacts when looking at the lowfer watering hole and my signal is QRV there from 
>> 23 miles. Think it's probably due to the SDR-IQ being overloaded and not real. Don't see any such 
>> thing on Jay's grabber, though the gain there is much lower and from the signal strength green 
>> line it's not as potent as what I'm getting.
>> -- 
>> 73, Garry, K3SIW, EN52ta, Elgin, IL
>> <capt030_slow_sdr-iq_00000_crop.jpg>______________________________________________________________
>> Lowfer mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/lowfer
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Lowfer at mailman.qth.net
>> Post must be less than 50KB total for message plus attachment!
>>
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
>
> ______________________________________________________________
> Lowfer mailing list
> Home: http://mailman.qth.net/mailman/listinfo/lowfer
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Lowfer at mailman.qth.net
> Post must be less than 50KB total for message plus attachment!
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html