[Lowfer] Frequency check M P 137780.5

[Mitch Powell]

G'day Lloyd and Garry:
Thanks - that was the sort of thing I needed....and both are very close to the same
readout so what I did is re-calibrate my ARGO to the frequency you both were reading - 
and then use that readout to QSY up a bit. I am showing just a tiny bit above 50 now - 
so will let it settle and hope it doesn't change again.

Thanks

Mitch 
On 2013-09-27, at 5:12 PM, Garry Hess wrote:

> Hi Mitch,
> 
> As you can see from Jay's grabber, your frequency is a bit low if .5 is the target. It's very strong here and I have the ARGO gain at normal (meaning "high"). I notice signal artifacts above and below the main signal with two separate e-probe/SDR-IQ receivers and also when I use a loop. I've seen such artifacts when looking at the lowfer watering hole and my signal is QRV there from 23 miles. Think it's probably due to the SDR-IQ being overloaded and not real. Don't see any such thing on Jay's grabber, though the gain there is much lower and from the signal strength green line it's not as potent as what I'm getting.
> -- 
> 73, Garry, K3SIW, EN52ta, Elgin, IL
> <capt030_slow_sdr-iq_00000_crop.jpg>______________________________________________________________
> Lowfer mailing list
> Home: http://mailman.qth.net/mailman/listinfo/lowfer
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Lowfer at mailman.qth.net
> Post must be less than 50KB total for message plus attachment!
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html