[Lowfer] WD2XNS WSPR-15 / WOLF pre-test test
jrusgrove at comcast.net
jrusgrove at comcast.net
Sun Feb 17 12:23:43 EST 2013
Stan
Yes ... it is WSPR-X that you want.
I would suggest the receiver be set to 136000 USB. The WOLF signal will then be centered on 800 Hz.
Set the WOLF decoder frequency to 800 Hz. The WSPR-X waterfall should show the WSPR-15 signal at
136000 +1614.
Jay
----- Original Message -----
From: "Stan, W1LE" <stanw1le at verizon.net>
To: <dexter.mc at gmail.com>; "Discussion of the Lowfer (US, European, & UK) and MedFer bands"
<lowfer at mailman.qth.net>
Sent: Sunday, February 17, 2013 11:12 AM
Subject: Re: [Lowfer] WD2XNS WSPR-15 / WOLF pre-test test
> Wolfie into Cape Cod at 10W.
>
> Any pointers to WSPR-15 ? I found a -20 and a -30 but no -15.
> Is it the latest X mode ?
>
> Do I keep the RX parked at 136.800 KHz for the WSPR and the WOLF ?
>
> Stan, W1LE Cape Cod FN41sr
>
>
> On 2/17/2013 10:59 AM, Dexter McIntyre W4DEX wrote:
>> Up and running:
>>
>> 2013-02-17 15:50:57 >WOLF10 -r 12000.75 -f 800 -t 1.0 -w 0.0000
>> t: 24 f:-0.768 a: 0.8 dp: 94.1 ci: 6 cj:441 YVPEZ2AKZ /A7 J ?
>> t: 48 f:-0.043 a:-0.6 dp: 92.0 ci:14 cj:458 WD2XNS 10W TX -
>> t: 96 f: 0.001 a:-1.5 dp: 91.9 ci: 5 cj:375 ZPYDUZNLT1WLK25 ?
>> t: 192 f:-0.039 pm:495.8 jm: 45 q: 5.4 5.0 WD2XNS 10W TX -
>> t: 288 f:-0.039 pm:929.9 jm: 45 q: 7.7 7.8 WD2XNS 10W TX -
>> t: 384 f:-0.039 pm: 1326 jm: 45 q: 9.1 9.3 WD2XNS 10W TX -
>> t: 480 f:-0.039 pm: 1723 jm: 45 q: 10.0 10.7 WD2XNS 10W TX -
>>
>> The only place I had my sound card sampling rate saved was in the wolf setup. I still have the
>> previous version wolf but the saved sampleing rate went to default after launching the latest
>> wolf. So I just guessed at the 12000.75 and it was close. I'll just use your transmission to
>> tweak the rate for now.
>>
>> Dex
>
> ______________________________________________________________
> Lowfer mailing list
> Home: http://mailman.qth.net/mailman/listinfo/lowfer
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Lowfer at mailman.qth.net
> Post must be less than 50KB total for message plus attachment!
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
More information about the Lowfer
mailing list