[Lowfer] WD2XNS in WOLF mode

[Stan, W1LE]

Now at 86W ????...

 From a cold start, off 1 + Hz. Shall calibrate after warmup.

Stan W1LE    Cape Cod   FN41sr


On 2/16/2013 9:41 AM, jrusgrove at comcast.net wrote:
> WD2XNS will be transmitting in WOLF mode for the next couple hours on 
> 136.800 kHz. Power level will be adjusted up and down and will be 
> indicated in the message.
>
> The GUI version of the decoder can be found at 
> http://www.qsl.net/d/dl4yhf/wolf/index.html . Be advised that this 
> mode is more critical than most in terms of sound card calibration. 
> There is a cal routine in the software if you have a known frequency 
> source.
>
> Reports are appreciated.
>
> Jay W1VD  WD2XNS  WE2XGR/2
> ______________________________________________________________
> Lowfer mailing list
> Home: http://mailman.qth.net/mailman/listinfo/lowfer
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Lowfer at mailman.qth.net
> Post must be less than 50KB total for message plus attachment!
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>