[Lowfer] WD2XNS in WOLF mode

[jrusgrove at comcast.net]

Forgot to add a warning ... WOLF normally runs at a sampling rate of 8000 so will not run at the 
same time as WSPR, WSPR-X etc that run at 12000.

Jay W1VD  WD2XNS  WE2XGR/2



----- Original Message ----- 
From: <jrusgrove at comcast.net>
To: <lowfer at mailman.qth.net>
Sent: Saturday, February 16, 2013 9:41 AM
Subject: [Lowfer] WD2XNS in WOLF mode


> WD2XNS will be transmitting in WOLF mode for the next couple hours on 136.800 kHz. Power level 
> will be adjusted up and down and will be indicated in the message.
>
> The GUI version of the decoder can be found at http://www.qsl.net/d/dl4yhf/wolf/index.html . Be 
> advised that this mode is more critical than most in terms of sound card calibration. There is a 
> cal routine in the software if you have a known frequency source.
>
> Reports are appreciated.
>
> Jay W1VD  WD2XNS  WE2XGR/2
> ______________________________________________________________
> Lowfer mailing list
> Home: http://mailman.qth.net/mailman/listinfo/lowfer
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Lowfer at mailman.qth.net
> Post must be less than 50KB total for message plus attachment!
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html