[Lowfer] SAQ in CT

[Michael Sapp]

Garry: Thanks for the info, especially you also receiving the carrier near 
17.2, so perhaps it is not a local source here.   RRR on the QRSS30, I was 
hoping for a key down event, especially in the tune-up period.

> The racket in your panoramic view looks like what my blower fan produces 
> when it's on (so I turn it off, even if it's 6 below, hi).
    I wish my solution was that simple....

    Your feedback much appreciated, 73,  Mike wa3tts





----- Original Message ----- 
From: "Garry Hess" <k3siw at sbcglobal.net>
To: "lowfer list" <lowfer at mailman.qth.net>
Sent: Tuesday, December 24, 2013 1:09 PM
Subject: Re: [Lowfer] SAQ in CT


> Mike, I saw a carrier just above 17.2 kHz too. It was fairly steady in 
> frequency as your ARGO plot shows. But QRSS30 is too narrow to show the 
> real SAQ. I was using Spec Lab at a setting comparable to QRSS3 and the 
> signal wobbled around toward the bottom of the display. The racket in your 
> panoramic view looks like what my blower fan produces when it's on (so I 
> turn it off, even if it's 6 below, hi). Unfortunately I'm still left with 
> a picket fence of 60 Hz products and they're much worse than they used to 
> be.
> -- 
> 73, Garry, K3SIW, EN52ta, Elgin, IL
> ______________________________________________________________
> Lowfer mailing list
> Home: http://mailman.qth.net/mailman/listinfo/lowfer
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Lowfer at mailman.qth.net
> Post must be less than 50KB total for message plus attachment!
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html