[Lowfer] WG2XRS/4 [WG4XRS for short] will start at 2200 with WSPR15...

[Bob Raide]

I am actually transmitting on 74.6135 as it shows clear whole in Europe right now.  Moved up .5 hz from 74.613 and database probably only shows full hz freqs. Bob


 
> From: listread at lwca.org
> To: lowfer at mailman.qth.net
> Date: Thu, 12 Dec 2013 18:03:43 -0600
> Subject: Re: [Lowfer] WG2XRS/4 [WG4XRS for short] will start at 2200 with	WSPR15...
> 
> Bob, it appears WSPR-15 is pretty forgiving of start time errors when the 
> signal is sufficiently in the clear, and yours certainly was before dark. 
> (I'll be returning out there momentarily to see what has happened since 
> then.)  I finally found my arithmetic error, but by the time I did it was 
> three and a half minutes into the 2200Z slot...and still got a good decode 
> anyway.  Two slots later, it looks as if you got a few seconds late start 
> after shifting the frequency back up one hertz, and still got a decode with 
> SNR showing in the minus-single-digit range.  Signal and ambient noise was 
> again just under AGC threshold, but with almost no static crashes today at 
> all prior to sunset!  Normal Morse would have worked fine over our path this 
> afternoon.  More when I next return from the field... 
> ______________________________________________________________
> Lowfer mailing list
> Home: http://mailman.qth.net/mailman/listinfo/lowfer
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Lowfer at mailman.qth.net
> Post must be less than 50KB total for message plus attachment!
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html