[Lowfer] wspr question

[pbunn at patbunn.com]

One thing that I am finding out (at least for my setup) is that if a loud 
station is transmitting in the WSPR bandwidth, then the RX noise detects the 
signal and runs the Rx noise into the red and decodes of the weak stations 
stop.

Right now , when Eric turns on his JT-9 signal - my Rx noise rise to +13 
db - when he is not transmitting the Rx noise is -2db. I was consistently 
decoding  WG2XIQ until he started transmitting. I have done one decode 
since. I can barely hear WG2XIQ  on and off with QSB and Eric is very loud.

When the Rx noise goes into the red - Does WSPR stop trying to decode?

Pat
N4LTA






-----Original Message----- 




From: Andy - KU4XR
Sent: Tuesday, December 04, 2012 12:50 AM
To:  European & UK) and MedFer bandsDiscussion of the Lowfer (US
Subject: Re: [Lowfer] wspr question

> On 4/12/2012 10:06, pbunn at patbunn.com wrote:
> " SAVE ALL IS CHECKED "
> > Pat

Pat: Having the " Save All " checked in WSPR causes the program
to " RECORD " the Received Audio, and save it to a .wav file..
Unless you have a massively large hard-drive, this can tend to
" Fill Up " the disk very quickly, and cause your PC to do some
crazy stuff because it runs out of space to write information to
the disk.. Unless you have a specific need to save the audio; it
might be advantageous to check " Save None " and - SAVE the HDD..

73:

Andy - KU4XR
______________________________________________________________
Lowfer mailing list
Home: http://mailman.qth.net/mailman/listinfo/lowfer
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Lowfer at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html