[Lowfer] 510.005 beacon on temp.

[Paul Cianciolo]

Stan, All,

I am using Argo at 3 sec mode currently.
The sweep takes 10 sec.

PauLC

-----Original Message-----
From: lowfer-bounces at mailman.qth.net
[mailto:lowfer-bounces at mailman.qth.net]On Behalf Of Stan W1LE
Sent: Wednesday, October 24, 2007 6:26 PM
To: Paulc at snet.net; Discussion of the Lowfer (US, European, & UK)
and MedFer bands
Subject: Re: [Lowfer] 510.005 beacon on temp.


Hello Paul,

Good to get your mail.

I am listening with ARGO. Active whip and IC-703+

What speed ARGO would be best to observe ?
How fast is the ramp up and down ?

Stan, W1LE   FN41sr



Paul Cianciolo wrote:

>Gentlemen,
>
>If anyone would be so kind as to look on 510.005 KHz for a beacon using a
>triangle wave as a identifier.
>The beacon currently consist of a 10' #12 vertical wire and a 2 wire
tophat.
>
>I am located about 3 miles NW of W1VD Jay, which is close to 20 miles North
>of Waterbury CT and 20 miles West of Hartford CT
>
>The ground at this early stage is a single ground rod and 2  60' radials.
>The vertical is tuned to resonance with a variometer.
>
>Power level at this time is 70 milliwatts.
>Improvements are being made as time permits.
>
>Thank you any reports would be welcomed.
>
>PaulC
>W1VLF
>
>_______________________________________________
>>From the Lowfer mailing list
>Send messages to: Lowfer at mailman.qth.net
>To sub/unsub visit: http://mailman.qth.net/mailman/listinfo/lowfer
>
>
>


_______________________________________________
>From the Lowfer mailing list
Send messages to: Lowfer at mailman.qth.net
To sub/unsub visit: http://mailman.qth.net/mailman/listinfo/lowfer