[Lowfer] MedFer CO in OR

Wed, 5 Nov 2003 23:31:53 -0600

Hey Dale,

It is an IC stage that works like an RF switch to cut the drive to the
driver stage with a computer enabling or disabling the IC's output for QRSS
or to use a keyer with paddles to run CW. I will most likely still build the
circuit to try it out that way. I use an Epson and computer to run the
exciter right now. The HP would allow me to move about the band as needed
where the Epson is rock bound.

Mike>WE0H

-----Original Message-----
From: [email protected] [mailto:[email protected]]
On Behalf Of Dale Rice
Sent: Wednesday, November 05, 2003 11:07 PM
To: [email protected]
Subject: Re: [Lowfer] MedFer CO in OR

Was Lyle going to use the HPIB interface to do that? I imagine a lot of
interesting stuff could be done through HPIB.

Dale R

> Your tracking signal is right where mine is; about 1.5 to 2hz lower than
> displayed frequency. I was going to use mine as an exciter for a beacon.
> Lyle drafted up an interface to key the HP for QRSS or CW.
>
> Mike>WE0H

_______________________________________________