[Lowfer] Island Pad Cutter

Fri, 7 Jun 2002 16:42:09 -0400

I use a Dremmel tool a lot ( you wonder what you did before you had one )
this looks like a pretty good deal and not that much more expensive over
a carbide
bit

Bob  K3DJC


On Fri, 07 Jun 2002 13:55:24 -0500 "Peter Barick"
<[email protected]> writes:
>LowFER List,
>Re: PCB Pad Cutter
>
>I found this PCB tool off of the ARRL site for making isolated spots 
>in
>the copper foil. Looks handy and quicker than an etch process.
>http://www.njqrp.org/islanderpadcutter/index.html
>
>Anyone used it? I'm guessing high speed is best, 1,500 RPM, right?
> 
>Peter
>_______________________________________________
>Lowfer mailing list
>[email protected]
>http://mailman.qth.net/mailman/listinfo/lowfer