[Lowfer] Re: 600MRG> Question about HP3586C SLV???

[Dexter McIntyre W4DEX]

Mike,

Set your Argo calibration frequency offset to 0.  Set the HP to 60 KHz. 
Run Argo in wide band mode and look for the carrier around 1850 Hz. 
Click on the line which will take Argo to narrow mode.  You can then
read the HP's BFO frequency.  Any frequency selected will give you this
same BFO output.  You can tinker with the Argo offset and make the freq
scale read 0 when you are tuned to a signal.

Dexter

WE0H wrote:
> 
> I now have the selective voltmeter sitting on my bench. Now, where do I set
> the VFO to see the beacons on ARGO? I think the BFO is 1.8kc. It seems like
> a hot receiver, as I can hear real signals from 60hz up into HF without any
> birdies. So the big task tonight is to find the carrier on ARGO. Also, I
> didn't get a manual for it; does anyone have one that I could get a copy
> of??? Contact me direct on the manual if you have one and we can discuss
> arrangements.
> Thanks es 73's,
> Mike>WE0H
> http://www.geocities.com/we0h/index.html