[LOGic] Logic 8 message

[k1vc at cox.net]

Hello All,

I run LOGic 8.0.104 with a Yaesu FT-1000D and FIF-232C CAT System.  From the time I open LOGic until I close out of it, I get the following message:

Yaesu FT-1000 (com1)
A timeout occurred while attempting to communicate with a rig.
Make sure a rig is turned on and check cabling and setup parameters.

POLLING DISABLED. 0 characters in buffer.

In order to have the radio communicate with LOGic, I have to go to TOOLS > Reset radio and Rotor Interface.

I can be sitting in front of the radio just listening and the message will pop up and I lose communication with the radio and LOGic.

My parameters are:

Radio 1: FT 1000 (6.0 or later ROM)
Port:  com1
Baud rate:  Ø  (should this be 4800?)
Stop Bits:  2
DTR and RTS both are checked.
Polling interval in seconds (polled rigs only):  2.0

Anyone experience the same problem?

Thanks,
Vin, 73
K1VC