[LOGic] [K3] Configuring Time Keeper

[Mel]

Go to Control Panel and try searching for new hardware.

Tim wrote:
> It's been awhile since I last used this fine program.  Think I must have
> changed the serial port (using USB adapter) and when I run the program it
> tells me there is no serial port.  I remember that when I first ran the
> program it allowed me to configure the port and baud rate.  Even after doing
> a new install into a new folder, I get the same message.  I turned off LOGic
> which also interfaces with the K3 so nothing else is connected.  Any ideas
> on how to reset the serial port for this program?  Thanks.
> 
> Tim K5OI
> 
> p.s. Worked K4M on 17M cw and 20M ssb with qrp on the K3.
> ______________________________________________________________
> LOGic mailing list
> Home: http://mailman.qth.net/mailman/listinfo/logic
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:LOGic at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>