[LOGic] [K3] Configuring Time Keeper

[Tim]

It's been awhile since I last used this fine program.  Think I must have
changed the serial port (using USB adapter) and when I run the program it
tells me there is no serial port.  I remember that when I first ran the
program it allowed me to configure the port and baud rate.  Even after doing
a new install into a new folder, I get the same message.  I turned off LOGic
which also interfaces with the K3 so nothing else is connected.  Any ideas
on how to reset the serial port for this program?  Thanks.

Tim K5OI

p.s. Worked K4M on 17M cw and 20M ssb with qrp on the K3.