[LOGic] Data type mismatch

[Mel]

No quotes around frequency... it is numeric, not a string.


----- Original Message ----- 
From: "Sante - IK0HBN" <ik0hbn at libero.it>
To: <logic at mailman.qth.net>
Sent: Saturday, January 10, 2009 7:07 PM
Subject: [LOGic] Data type mismatch


> Hi guys,
> may you help me in troubleshooting this error?
> One step back....
> 
> Mauro, IK0CHU helped me at putting at work a report done by Hal, NN8L 
> some years ago that I should use to print qso's direct on qsl card.
> My card accepts till 4 qso's for card, so we were able to print them 
> without problem, putting the FREQ read on the log directly on the card.
> 
> As I began with radio more than 20 years ago, old logging program did 
> not save the frequency in the log itself, so Mauro put an expression 
> that filled the missing frequency with the band, eg 20M, 15M and so on.
> 
> If I had only a qso with BAND printed on the card, everthing runs 
> fine here, but if I have more than a qso to have printed on the card, 
> if this /these qos's had the band to be printed too,
> the result was having the first qso with the correct band on the 
> card, and from the second to the fourth, if exist, having the same 
> band of the first qso.
> EG.
> 1 qso: 20M (OK)
> 2 qso: 15M (got printed 15M)
> 3 qso: 40M  got printed 15M).
> As unable to fix the report, we thought to put a "static frequency" 
> in all the FREQ field having care to respect bandplan, so:
> 1 qso on 14 CW, should write 14.000
> 1 qso on 14 RTTY , 14090
> 1 qso on ssb 14250,
> so to force the report to print the frequency on the card. We use 
> MASS CHANGE in ADVANCED
> We did the following expression:
> replace freq with "14.243" for BAND='20M' AND EMPTY(FREQ) AND MODE='SSTV'
> 
> but we got Data type Mismatch.
> Any idea for both the problem or even the last one?
> Thank you
> Sante
>  
> 
> _______________________________________________
> LOGic mailing list
> LOGic at mailman.qth.net
> http://mailman.qth.net/mailman/listinfo/logic