[LOGic] issue with 2 rigs

[Jack - K4WSB]

I belive you have to change the address on the 2nd rig & in Logic

At 02:08 PM 6/15/2008, you wrote:
>I have 2 Icom rigs connected to 2 different serial ports via 2 separate
>Converters, IC-756 pro3 on com6 and an IC-7000 on com5.
>
>If I enable both rigs at the same time in setup I always get
>A timeout on the second rig and a message that says
>'interface found but no rig found at address 70h on com6"
>
>That's correct cause the rig is on com5 and set to com5 in the setup
>Not com6.
>
>Its as if radio1 has precedence over them all if its another Icom rig,
>Setting the rig type to yaesu corrects the port but obviously don't
>Communicate with the rig.
>
>The reason I have 2 separate ports is cause I was getting timeouts
>While talking to the rigs even running at 19200 baud.
>
>Is there a way to have separate com ports on Icom rigs?
>
>KF7NN

Jack Hartley
K4WSB / VP2MSB
ARRL - QCWA - OOTC
DXCC Honor Roll