[LOGic] issue with 2 rigs

[George Vagner]

I have 2 Icom rigs connected to 2 different serial ports via 2 separate 
Converters, IC-756 pro3 on com6 and an IC-7000 on com5.

If I enable both rigs at the same time in setup I always get 
A timeout on the second rig and a message that says 
'interface found but no rig found at address 70h on com6"

That's correct cause the rig is on com5 and set to com5 in the setup
Not com6.

Its as if radio1 has precedence over them all if its another Icom rig,
Setting the rig type to yaesu corrects the port but obviously don't 
Communicate with the rig.

The reason I have 2 separate ports is cause I was getting timeouts
While talking to the rigs even running at 19200 baud.

Is there a way to have separate com ports on Icom rigs?

KF7NN