[Logic] SERIAL PORT ERROR?

[Dave]

Dan,

I have been having the same problem here using Logic7. I have tried changing
ports and the timing to poll the rig. So far nothing has worked to resolve
the problem. Maybe it's time to get Dennis involved.

Jacques
k5dv at arrl.net


-----Original Message-----
From: logic-bounces at mailman.qth.net [mailto:logic-bounces at mailman.qth.net]
On Behalf Of k0dan
Sent: Tuesday, September 07, 2004 10:44 PM
To: logic at mailman.qth.net
Subject: [Logic] SERIAL PORT ERROR?

Hi folks...

Been running LOGic6 for several years, including rig interface. All OK.

Recently purchased LOGic7, and am running both 6 and 7 from different
directories during the transition debugging.

Suddenly, the rig interface no longer works. The error I get is a pop-up
window stating
A TIMEOUT OCCURED WHILE ATTEMPTING TO COMMUNICATE WITH A RIG. MAKE SURE RIG
IS TURNED ON AND CHECK SETUP PARAMETERS. POLLING DISABLED. 4 CHARACETRS IN
BUFFER. F0-40-02-00.

The rig is powered up, cable is OK, and setup parameters are unchanged. In
fact nothing is changed.

The error pops up if I start LOGic6 or LOGic7. I am speaking of a problem
when running only ONE of the LOGic programs; of course both simultaneously
will not share the COM port.

I believe this propblem only cropped up since I installed LOGic7 in a new
directory.

Any ideas what is going on here?

Thanks and 73
Dan
K0DAN

_______________________________________________
LOGic mailing list
LOGic at mailman.qth.net
http://mailman.qth.net/mailman/listinfo/logic