[Logic] Hamscope & Rig Freq (Band) Control

[Mark Hinkleman]

I'm running Logic 7 (7.0.100) and Hamscope (1.54). For the most part the interface between the two programs works well. But I do have a problem with the logging of the frequency. Here is what happens.

When from Hamscope I hit the "log it" button the QSO logs OK, but the band is always 20 meters. It will always log the frequency correctly (ie..21085.0) but the band will say 20 meters. Also it should be noted that the band tries to change. When on 15 meters (or other bands) I notice that the band will change to the correct band for about 1/4 of a second, then it pops back to record 20 meters. It's trying to record the correct band but it gets overwritten some how. 

I have tried a number of settings in Hamscope. This is what I have now.

Radio com port =  com 1 (this is the port I use)
Radio = Logic 6
Rig Baud = 4800

Log Program = Logic 6

Can anyone give me some advice? 
What settings do you use? Are mine correct?
Is there anything in the set up of Logic that would cause this? (Radio works fine from Logic) (I use FT1000MP, Com 1, 4800 baud, 2 stop bits, DTR&RTS with 2 second polling.)

Thanks 
Mark NU8Z


-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://mailman.qth.net/pipermail/logic/attachments/20040510/c48dd4df/attachment.htm