[Logic] "CW" vs "CWN" modes with Yaesu rig

[Bill VanAlstyne]

Here's a question that has nothing to do with LOGic 7 -- at least I don't think
so.  :-)  I'm still running LOGic 6.

I have a Yaesu FT-897 that reports its mode as "CW" when the 2300 Hz filter is
engaged in CW mode, and as "CWN" when the 500 Hz filter is engaged in CW mode.
This "CWN" thing is propagating all the way to my QSL printing report, and I
want it to go away. I tried deleting it from the Modes list, but the mode then
just shows up blank. I don't know how to get the rig to report just "CW" without
referencing what receive filter is being used. (Who on earth cares???) Is there
anything I can do to make LOGic interpret CWN as just plain old CW? I think I
know how to construct an expression in the QSL printing report that will print
"CW" when either mode=CWN or mode=CW, but I'm wondering if there is a way to
prevent this CWN thing fromn showing up anywhere in LOGic.

Same thing would apply to "USB" and "LSB" instead of just plain old SSB, which I
would greatly prefer -- but that doesn't irritate me as much as "CWN". USB and
LSB actually mean something, as opposed to CWN.

Anybody else find this Yaesu behavior undesirable? I'm going to post on the
FT-897 Yahoo group also, and see what I can find out.

Bill / W5WVO