[Logic] New Computer

[Jim Reid]

Chris wrote:


> I don't know for sure what you filled in but when you go to the Setup
> Station Information screen don't put your state or callsign on the left
> hand side of the screen. Input your actual Lat and Lon according to
> Logic's instructions and don't forgot the Minus sign if appropriate. You
> can then put in the callsign, state, etc. on the right hand side of the
> screen. Also, try leaving the Grid Square info off the screen and it
> should fill that in too.

Yes,  that is exactly what I have done.  Filled in my Lat as
21.919 and Long as -159.498 (GPS coordinates of QTH);
and my correct Grid Square is filled in.  Then,  the program
asks,  "Redraw the Map";  I click Yes.  Then I go check the
station set up screen again,  and the Lat is shown as -33 !??
But the Long still reads as entered.

When first booting up Logic 6,  I am now getting this error message:

Error 26 has occurred in program Log_Form.LOAD,  line 7.  With the
note "Table has no index order set."  Have no idea what that is
about, hi.

73,  Jim  KH7M