[Logic] Rotor setting

Mon, 08 Jul 2002 06:08:10 +0200

Thank you for your suggestions. At last I found the gap: it was my fault. I 
did not link the rotor selection to the used LOGFORM. Now it runs like a 
train. Rotor is an ORION 2800 set at 9600 n81.

Thanks again for your help.
Sante

At 17.18 07/07/2002 -0500, you wrote:
>Hi all,
>
>Not knocking the technology of automatic rotor control, but it
>does have limitations especially in DXing.  For real long haul
>stuff, sometimes a skewed path, from a very unexpected direction
>will yield the greatest signal.  Another example is backscatter.
>Yesterday, CY9DH came on 10M and started working a pileup.
>When I pointed right at him he was gone.  When I pointed SE
>his signal came up and I worked him on BS.
>
>Your mileage may vary,
>
>Ken AB5A
>
>-----Original Message-----
>From: [email protected] [mailto:[email protected]]On
>Behalf Of K1UQ
>Sent: Friday, July 05, 2002 6:38 PM
>To: [email protected]
>Subject: Re: [Logic] Rotor setting
>
>
>Sante,
>
>you did not mention how you control your rotator (hardware) and what you
>have for a rotator.  If it is SARtek controller, here are my settings:
>
>Rotor 1:        SARtek 1B
>Port:              COM2
>Baud Rate:    1200
>Stop Bits:      1
>Description:  G-800SDX
>Reverse:        Selected
>
>Rotor 2:        (none)
>
>
>Try selecting:   Reset Radio & Rotor Interfaces.
>
>GL & 73,  Bill  K1UQ
>
>----- Original Message -----
>From: "Sante - IK0HBN" <[email protected]>
>To: <[email protected]>
>Sent: Wednesday, July 03, 2002 2:08 AM
>Subject: [Logic] Rotor setting
>
>
> > Hi Logic users,
> > I finally found a multi serial port to allow all the stuffs connected to
> > Logic running. I have just one problem when recalling the ROTOR HEAD
>window
> > and trying to beam the antenna somewhere. Below the error message I got:
> > "The last-selected log form doesn't have a Rotor Interface associated
>with
> > it. Please select a log form with an associated rotor interface".
> >
> > Where I wrong? I have just selected the Rotor type and port in TOOLS >
> > SETUP >  STATION INFORMATION,MISC HAM SETUP, RIG, TNC....
> >
> > Ps. It does not matter changing the COM port....
> > Thanks in advance.
> > Sante
> >
> > _______________________________________________
> > LOGic mailing list
> > [email protected]
> > http://mailman.qth.net/mailman/listinfo/logic
> >
>
>_______________________________________________
>LOGic mailing list
>[email protected]
>http://mailman.qth.net/mailman/listinfo/logic
>
>
>--- StripMime Report -- processed MIME parts ---
>multipart/signed
>   text/plain (text body -- kept)
>   application/x-pkcs7-signature
>The reason this message is shown is because the post was in HTML
>or had an attachment. Attachments are not allowed.
>Please post in Plain-Text only.---
>_______________________________________________
>LOGic mailing list
>[email protected]
>http://mailman.qth.net/mailman/listinfo/logic