[Logic] Rotor setting

Fri, 5 Jul 2002 19:38:16 -0400

Sante,

you did not mention how you control your rotator (hardware) and what you
have for a rotator.  If it is SARtek controller, here are my settings:

Rotor 1:        SARtek 1B
Port:              COM2
Baud Rate:    1200
Stop Bits:      1
Description:  G-800SDX
Reverse:        Selected

Rotor 2:        (none)

Try selecting:   Reset Radio & Rotor Interfaces.

GL & 73,  Bill  K1UQ

----- Original Message -----
From: "Sante - IK0HBN" <[email protected]>
To: <[email protected]>
Sent: Wednesday, July 03, 2002 2:08 AM
Subject: [Logic] Rotor setting

> Hi Logic users,
> I finally found a multi serial port to allow all the stuffs connected to
> Logic running. I have just one problem when recalling the ROTOR HEAD
window
> and trying to beam the antenna somewhere. Below the error message I got:
> "The last-selected log form doesn't have a Rotor Interface associated with
> it. Please select a log form with an associated rotor interface".
>
> Where I wrong? I have just selected the Rotor type and port in TOOLS >
> SETUP >  STATION INFORMATION,MISC HAM SETUP, RIG, TNC....
>
> Ps. It does not matter changing the COM port....
> Thanks in advance.
> Sante
>
> _______________________________________________
> LOGic mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/logic
>