[Logic] User defined fields

[Mac McDaniel]

Charlie,

I hope this is what your looking for. After unlocking the log form try
clicking
on the trash can. Find the field name you are looking for and double click
on it.. It should now show up in the log form.
73, Mac  N0OB


> I have used Logic since the late 80's and have always dreaded when a new
> release came out. I always seem to have some problem getting everything
> converted. After saying that I will state that their is no other logging
> program that comes close to the power of Logic, and will continue to dread
> the new releases, Hi, Hi...
>
> The problem: After adding two new user fields, getting the data block and
> field name on the "Log main", anyother user field just shows the "data
> block", no name.
>
> Yes, I went to Setup, List values, and entered the data, then on the log
> form opened user defined field setup and selected the field I wanted to
add
> to the Log, then unlocked and unhide the field that I needed to unhide.
>
> As said, the data block shows but no name as the other two did! I have
> checked my data several times, seems fine, even deleted Logic 6 from my
> computer and reloaded, nothing has worked.
>
> I might mention that I have not transferred my Logic 5 to Logic 6 as of
yet.
> I did do it on the first load of "6" and it still didn't make any
> difference, same problem.
>
> Any ideas????
>
> Logic 6 Ver 6.0.111  WinME  Pentium 3 computer
>
> Would I buy Logic again....as said, nothing beats it!
> Charlie Carpenter  W5NMX
> Alamogordo, Otero Cnty, NM
> ---
> This e-mail account is protected from unsolicited e-mail by SpamJammer --
http://www.spamjammer.ca/info/
>
> _______________________________________________
> LOGic mailing list
> LOGic@mailman.qth.net
> http://mailman.qth.net/mailman/listinfo/logic
>