[Logic] User defined fields

[Charlie Carpenter]

I have used Logic since the late 80's and have always dreaded when a new
release came out. I always seem to have some problem getting everything
converted. After saying that I will state that their is no other logging
program that comes close to the power of Logic, and will continue to dread
the new releases, Hi, Hi...

The problem: After adding two new user fields, getting the data block and
field name on the "Log main", anyother user field just shows the "data
block", no name.

Yes, I went to Setup, List values, and entered the data, then on the log
form opened user defined field setup and selected the field I wanted to add
to the Log, then unlocked and unhide the field that I needed to unhide.

As said, the data block shows but no name as the other two did! I have
checked my data several times, seems fine, even deleted Logic 6 from my
computer and reloaded, nothing has worked.

I might mention that I have not transferred my Logic 5 to Logic 6 as of yet.
I did do it on the first load of "6" and it still didn't make any
difference, same problem.

Any ideas????

Logic 6 Ver 6.0.111  WinME  Pentium 3 computer

Would I buy Logic again....as said, nothing beats it!
Charlie Carpenter  W5NMX
Alamogordo, Otero Cnty, NM
---
This e-mail account is protected from unsolicited e-mail by SpamJammer -- http://www.spamjammer.ca/info/