[Kenwood] signal spec to adjust mic ALC meter in TS-940

[Clif]

I've always used RMS.

On Thu, Mar 19, 2015 at 7:18 AM, MarioDaniele Greco <daniele_mdg at yahoo.it>
wrote:

> hi all,wanting check the ALC meter , if I follow the service manual of
> TS-940, it says to use a signal 1,5 KHz, 5 mV for minimum ALC, then 10 mV
> for ALC full scale. But , maybe it is a stupid question, don't know if the
> spec is for peak volt or rms volt. There is a 1,41 factor, I think it's
> important. I could not find it in the manual. Any help truly appreciated.
> ______________________________________________________________
> Kenwood mailing list
> Home: http://mailman.qth.net/mailman/listinfo/kenwood
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Kenwood at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>



-- 
Clif Holland KA5IPF
www.avvid.com